1、多层穿梭车货架货架制造⼯艺按照 JB/T5323-91⾏业标准。 2、货架⽴柱⽚全长孔距误差为±2毫⽶ ，⽴柱⽚宽度极限差±2毫⽶，⽴柱⽚侧⾯及 ⽴柱内外弯曲偏差不⼤于H/1000毫⽶,且≤ 3mm，⽴柱与底版垂直偏差在500毫⽶⾼度 范围内不⼤于0.5毫⽶。 3、货架焊缝和贴⾓焊缝的外形尺⼨偏差 符合GBJ205规定。 4、货架表⾯喷塑处理丰满光滑、⽆⾊ 差、⽆缩孔花包现象。 5、货架的安装、调试、交验的依据：国 标GB50205-2001、⾏业标准JB/T5323-91。 

1. The manufacturing process of multi-layer shuttle  car rack and shelf shall comply with JB/T5323-91  industry standard. 2. The overall hole spacing error of rack column  sheet is ± 2mm, the limit difference of column sheet  width is ± 2mm, the bending deviation of column sheet  side and column inside and outside is not more than  H/1000mm, and ≤ 3mm, and the vertical deviation of  column and bottom plate is not more than 0.5mm  within the height range of 500mm. 3. The overall dimension deviation of rack welds  and fillet welds shall comply with GBJ205. 4. The surface of the shelf shall be sprayed with  plastic to make it plump and smooth, without color  difference and shrinkage cavity. 5. The basis for installation, commissioning and  acceptance of the shelf: GB 50205-2001, industry  standard JB/T5323-91.